Removal and Installation
- Remove the rear door speaker. For additional information, refer to INFORMATION SYSTEM AND ENTERTAINMENT SYSTEM article.
- Remove the watershield.
- Temporarily install the window control switch or the window regulator handle to raise or lower the window to align the regulator clamp with the access hole.
- Push out the pin and then push out the sleeve of the 2-part spacer.
- Supporting the glass, lower the glass and regulator to the lowest position.
- Remove the door glass top run.
- To install, reverse the removal procedure.
NOTE:
Do not touch the adhesive surface during removal or installation of the watershield, as re-bonding will be impaired. If additional adhesive is required during installation, apply seam sealer as necessary to completely seal the watershield to the inner door.