Removal and Installation

Place the roof opening panel in the full OPEN position.
From the top of the vehicle, press the spring steel locating tab downward on each side with a flat-blade screwdriver while pushing the deflector toward the rear of the vehicle.

Fig 1: Pressing Spring Steel Locating Tab Downward
Courtesy of FORD MOTOR CO.
Tilt the air deflector upward and pull forward to remove.

Fig 2: Tilting Air Deflector
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Make sure the locating tabs are firmly locked in place.
- Initialize the roof opening panel motor. For additional information, refer to ROOF OPENING PANEL MOTOR INITIALIZATION .