Removal and Installation
- Push the buttons on the head restraint guides and remove the head restraint(s).
- Remove the head restraint guides.
- Insert an appropriate flat-blade screwdriver along side the head restraint guide below the backrest cover and release button.
- Release the locking tab and pry upward to remove.
- Release the lower J-clip and hook-and-loop strip.
- Invert the backrest cover and remove the row of hog rings.
- Invert and remove the backrest cover.
- Route the latch release strap through the backrest cover opening.
- To install, reverse the removal procedure.
NOTE:
If the locking tab on the head restraint guide is damaged during removal, a new head restraint guide must be installed.
NOTE:
Use care when separating the backrest trim cover from the hook-and-loop strips, or the hook-and-loop strips can be torn from the backrest foam pad.