Fog Lamp Adjustment Screw Location

Fig 1: Fog Lamp Adjustment Screw Location

Courtesy of FORD MOTOR CO.

NOTE: Horizontal aim is not required for this vehicle and is not adjustable. Consult your state vehicle inspection center for recommended tolerance ranges for visual aiming.

Before starting the fog lamp assembly adjustment:
- check the tire inflation.
- make sure there are no other loads in the vehicle other than a half tank of fuel.
- make sure the vehicle is on level ground.
- make sure the fog lamps and headlamps are clean.
- make sure the headlamps are operating and are correctly aimed.

NOTE: The vertical wall screen must be a minimum of 2.4 m (8 ft) wide.

Fig 2: Vehicle Parking Distance From Vertical Wall Or Screen

Courtesy of FORD MOTOR CO.

Park the vehicle on a level surface approximately 7.6 m (25 ft) from the vertical wall or screen directly in front of it.
The correct visual aim for the fog lamps is with the top edge of the high-intensity zone 10 cm (4 in) below the horizontal center of the fog lamps.

Fig 3: Correct Visual Aim For Fog Lamps
Courtesy of FORD MOTOR CO.
If necessary, rotate the adjusting screw until the fog lamp beam is within specification.