Wheel Speed Sensor - Rear

Wheel Speed Sensor - Rear









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the wheel speed sensor bolt.
- To install, tighten to 9 Nm (80 lb-in).

3. NOTE: Not all the clips are part of the sensor assembly and may not be reusable.

Disconnect the wheel speed sensor electrical connector.

- Remove the sensor by detaching the pin-type retainer and pulling the sensor grommets out of the clips.

4. To install, reverse the removal procedure.