LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Flex SE >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation System, Message Center & Warning Chimes >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test AX: DTC U0208 >> Pinpoint Test Ax: DTC U0208

Pinpoint Test Ax: DTC U0208

  1. AX1 VERIFY THE CUSTOMER CONCERN 
    • Ignition ON.
    • Verify that there is an observable symptom present.
    • Is an observable symptom present? 
    • Yes:  Go to AX2  .
    • No:  The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
  2. AX2 CHECK THE COMMUNICATION NETWORK 
    • Enter the following diagnostic mode on the scan tool: Network Test.
    • Carry out the network test.
    • Does the DSM pass the network test? 
  3. AX3 RETRIEVE THE RECORDED DTCs FROM THE IC SELF-TEST 
    • Check for recorded IC  DTCs from the self-test.
    • Is DTC B1317 or DTC B1318 recorded? 
  4. AX4 RECHECK THE IC DTCs 
    NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the Programmable Module Installation (PMI) or the PMI may not have been carried out.
    • Clear the DTCs. Repeat the IC  self-test.
    • Is DTC U0208 still present? 
    • Yes:  INSTALL a new DSM  . Refer to MULTIFUNCTION ELECTRONIC MODULE . CLEAR the DTCs. REPEAT the IC  self-test.

      If DTC U0208 is still present, INSTALL a new IC  . Refer to INSTRUMENT CLUSTER (IC)  in this information. TEST the system for normal operation.

    • No:  The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
scientia non olet · About LEMON Manuals