LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Flex SE >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation System, Message Center & Warning Chimes >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test AH: The Key-In-Ignition Warning Chime Is Inoperative >> Pinpoint Test Ah: The Key-In-Ignition Warning Chime Is Inoperative

Pinpoint Test Ah: The Key-In-Ignition Warning Chime Is Inoperative

  1. AH1 CARRY OUT THE CHIME FUNCTION ACTIVE COMMAND 
    • Ignition ON.
    • Enter the following diagnostic mode on the scan tool: IC  DataLogger.
    • Select the IC  chime command (CHIME_KEY).
    • Does the chime operate? 
    • Yes:  Go to AH2  .
    • No:  INSTALL a new IC  . Refer to INSTRUMENT CLUSTER (IC)  in this information. TEST the system for normal operation.
  2. AH2 CHECK THE DOOR AJAR WARNING INDICATOR OPERATION 
    • Ignition ON.
    • Open then close the LH front door while observing the door ajar warning indicator in the IC  .
    • Does the door ajar warning indicator operate correctly? 
  3. AH3 RETRIEVE THE RECORDED DTCs FROM THE SJB SELF-TEST 
    • Check the recorded DTCs from the SJB  self-test.
    • Is DTC B1352 present? 
  4. AH4 CHECK THE IGNITION SWITCH 
    • Ignition OFF.
    • Disconnect: Ignition Switch C250.
    • Carry out the ignition switch component test.

      Refer to ENGINE CONTROLS - COMPONENT TESTING for component testing.

    • Is the ignition switch OK? 
    • Yes:  REPAIR circuit CDC30 (BU/GY) for an open. CLEAR the DTCs. REPEAT the self-test.
    • No:  INSTALL a new ignition switch. Refer to STEERING COLUMN SWITCHES . CLEAR the DTCs. REPEAT the self-test.
scientia non olet · About LEMON Manuals