Pinpoint Test Ad: The Check Fuel Fill Inlet Message Is Inoperative/Always On

AD1 CHECK THE MESSAGE CENTER OPERATION
- Close all doors, liftgate and hood.
- Ignition ON.
- Open the driver door while monitoring the message center displays.
- Does the message center display DRIVER DOOR AJAR?
- Yes: Go to AD2 .
- No: Go to PINPOINT TEST AA .
AD2 RETRIEVE THE RECORDED DTCs FROM THE PCM KOEO SELF-TEST
- Check for recorded PCM DTCs from the Key ON Engine OFF (KOEO) self-test.
- Is DTC P0457 recorded?
- Yes: If the CHECK FUEL FILL INLET message is illuminated, refer to the INTRODUCTION .
  If the CHECK FUEL FILL INLET message is not illuminated, go to AD3 .
- No: If the CHECK FUEL FILL INLET message is always on, INSTALL a new IC . Refer to INSTRUMENT CLUSTER (IC) in this information. TEST the system for normal operation.
  If the CHECK FUEL FILL INLET message is not illuminated, the system is operating normally at this time. If the fuel inlet was open and the CHECK FUEL FILL INLET message did not turn on, driving conditions may not have allowed for the PCM to run the cruise test and message the IC to turn the CHECK FUEL FILL INLET message on.
AD3 RETRIEVE THE RECORDED DTCs FROM THE IC SELF-TEST
- Check for recorded IC DTCs from the self-test.
- Are any DTCs recorded?
- Yes: For DTC U0100, go to PINPOINT TEST AO .
  For all other DTCs, refer to the DTC CHARTS in this information.
- No: INSTALL a new PCM. Refer to ELECTRONIC ENGINE CONTROL SYSTEM . TEST the system for normal operation.