Diagnostic Mode

The refrigerator can be switched into a diagnostic mode to read the potential error codes of the compressor. When the refrigerator is in diagnostic mode, the COOL LED on the refrigerator switch will flash 1-5 times, depending on the error. Perform the following steps in order to access the refrigerator diagnostic mode:

1. Turn the ignition switch to the ON position.
2. Depress the refrigerator switch to the FREEZE position for approximately 1 second, until the FREEZE LED illuminates.
3. Depress the refrigerator switch again to the FREEZE position for approximately 5 seconds, until the FREEZE LED flashes quickly and repeatedly.
NOTE: Use the Diagnostic Mode Error Code Chart to determine the error.
4. When the FREEZE LED is quickly flashing, the COOL LED will display the error code by flashing 1-5 times, depending on the error.
NOTE: If the refrigerator is in diagnostic mode and the ignition is turned OFF, the refrigerator will restart in FREEZE mode when the ignition is turned back to the ON position.
5. To turn the diagnostic mode off, depress the refrigerator switch to the FREEZE position for approximately 1 second. The FREEZE LED will stop flashing, but it will remain illuminated and the refrigerator will be in freeze mode.