Removal and Installation
NOTE:
Do not service the brake booster without first removing the stoplamp switch and the cruise control deactivator switch. Remove these switches with the brake pedal in the at-rest position. Attempting to remove these switches when the plunger is extended (during pedal apply) results in damage to the switches.
NOTE:
Do not press, pull or otherwise move the brake pedal while installing the stoplamp switch and cruise control deactivation switch. Install these switches with the booster push rod attached to the brake pedal and with the brake pedal in the at-rest position. Installing these switches with the brake pedal in any other position results in incorrect adjustment and damages the switches.
NOTE:
The booster push rod clevis locking pin is a one-time use only part. Any time the booster push rod clevis locking pin is removed, install a new booster push rod clevis locking pin.
NOTE:
Use an 11 mm, 12-point socket or wrench to compress the 2 locking tabs on the clevis pin.
- Remove the stoplamp switch. For additional information, refer to EXTERIOR LIGHTING .
- Remove the cruise control deactivator switch. For additional information, refer to CRUISE CONTROL .
- Refer to items in the exploded views which may not be listed in order of removal.NOTE: In order to ensure the most accurate information, some procedural and pinpoint test steps may be under development and not immediately available at vehicle introduction.
- Verify correct stoplamp switch and cruise control deactivator switch installation. For additional information, refer to Brake Pedal Switch Adjustment in VEHICLE DYNAMIC SYSTEMS .