LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Fiesta SEL, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - Automatic Shifting Manual Transmission/Transaxle) >> General Procedures >> Clutch Adaptive Learning >> Special Tool(s)

Special Tool(s)

WARNING: This page is about a different variant/trim than selected.
SPECIAL TOOLS CHART

G06939249
 Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool
  1. Using the scan tool, select Module Programming and Programmable Parameters under the toolbox icon.
  2. Select transmission. Follow the instructions displayed on the scan tool.
  3. Verify that the calibration file is present on the scan tool. If the file is present, go to Step  10. If the file is not present, continue with this procedure.
  4. Update the PCM/TCM calibration. Calibration files maybe obtained at Professional Technician Society (PTS) website. Independent Technicians refer to www.motorcraft.com. The scan tool checks to see if the file is present on the scan tool. If the calibration file is present, the technician may proceed with downloading the file to the PCM/TCM. If the file is not present, the scan tool will need to be connected to the server to download the file onto the scan tool.
  5. Connect the scan tool to the PTS  server.
  6. Follow the instructions on the network to download the strategy file to the scan tool.
  7. If the scan tool cannot connect to the PTS  server, download the file from www.motorcraft.com. If the scan tool cannot download a strategy from the web site, a partial strategy will automatically be downloaded.
  8. Reconnect the scan tool to the vehicle.
  9. Enter the Transmission Teach-in mode.
  10. Perform all three of the teach-in routines - "TRS", "Shift Drum" and "Clutch".
  11. Drive the vehicle to perform adaptive strategy learn on a level road surface.
    1. Depress vehicle brake pedal (do not use parking brake).
    2. Shift to Drive.
    3. Wait 15 seconds.
    4. Shift to Reverse.
    5. Wait 2 seconds.
    6. repeat (1-5) ten (10) times.
    7. Accelerate from a stop with light throttle to 15mph (24 km/h).
    8. Brake gently to a complete stop (allow at least 6 seconds).
    9. Repeat steps (7-8) five (5) times in dealership parking lot or similar setting.
    10. Accelerate from a stop with light throttle performing 1-2, 2-3, 3-4 shifts maintaining 1700-2000 RPM.
    11. Accelerate to a speed between 50 mph and 65 mph, achieve 6th gear, keep throttle steady with engine below 3000 RPM for a minimum of two (2) minutes.
    12. Repeat step 11 two (2) times.
    12. NOTE: If a drive cycle is not completed, the customer may feel erratic shifts and driveability concerns.
  12. Test drive the vehicle.
scientia non olet · About LEMON Manuals