Leakage Inspection: Material

WARNING: This page is about a different variant/trim than selected.

MATERIAL SPECIFICATIONS

Item	Specification
Motorcraft® Dual Clutch Transmission Fluid XT-11-QDC	WSS-M2C200-D2

NOTE: Do not try to stop the transmission fluid leak by increasing the torque beyond specification. This may cause damage to the case threads.

If leakage is found at the Transmission Range (TR) manual control lever, install a new seal. Refer to MANUAL CONTROL LEVER SHAFT SEAL in this information.

If leakage is found at the TCM , install a new O-rings. Refer to TRANSMISSION CONTROL MODULE (TCM) in this information.

Check the fill plug and drain plug. If leakage is present refer to TRANSMISSION DRAINING AND FILLING in this information.

Check all the speed sensors for leakage. Refer to INPUT SHAFT SPEED SENSOR - NO. 1 , INPUT SHAFT SPEED SENSOR - NO. 2 or OUTPUT SHAFT SPEED (OSS) SENSOR in this information.

Check the RH and LH halfshaft seals. Refer to HALFSHAFT SEAL - RH and HALFSHAFT SEAL - LH in this information.

The transaxle has the following parts to prevent external transmission fluid leakage:

Sealer
O-ring seals