Symptom Chart: Parking Aid - Video

Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to DIAGNOSTIC METHODS for information regarding Ford-specific diagnostic practices.

SYMPTOM CHART - PARKING AID (VIDEO)

Condition	Possible Sources	Actions
The rear video is inoperative	Fuse Wiring, terminals or connectors Video camera Accessory Protocol Interface Module (APIM) Body Control Module (BCM)	REFER to Diagnostic Routine I .
The Front Display Interface Module (FDIM) displays PLEASE CHECK SURROUNDINGS FOR SAFETY and a black screen/no image or displays an error message	Fuse Wiring, terminals or connectors Video camera Accessory Protocol Interface Module (APIM) Body Control Module (BCM)	NOTE: It may take up to 30 seconds before the message is displayed on the Front Display Interface Module (FDIM). REFER to Diagnostic Routine I .
Static/flashing/blinking/flickering/scrolling or rolling image/screen/scrolling horizontal lines	Wiring, terminals or connectors Video camera	REFER to Diagnostic Routine J .
Poor image quality (foggy/cloudy/fuzzy/blurry/hazy image or moisture/water in lens or black spots)	Wiring, terminals or connectors Video camera	REFER to Diagnostic Routine J .
Manual zoom function is inoperative	Manual zoom feature is disabled Video camera	CARRY OUT the video camera configuration using the scan tool under Body > RVC Configuration. REFER to Diagnostic Routine I .
The visual park aid alert is inoperative	Wiring, terminals or connectors Video camera Body Control Module (BCM) Parking Aid Module (PAM)	CARRY OUT the video camera configuration using the scan tool under Body > RVC Configuration. REFER to Diagnostic Routine L .
Fixed guidelines are not displayed on the video image	Fixed guidelines feature is disabled Video camera	CARRY OUT the video camera configuration using the scan tool under Body > RVC Configuration. REFER to Diagnostic Routine M .
Active guidelines are not displayed on the video image	Video camera not configured after replacement	CARRY OUT the video camera configuration using the scan tool under Body > RVC Configuration.
Active guidelines are not displayed on the video image	Active guidelines feature is disabled Steering wheel position data error Video camera	REFER to Diagnostic Routine M .
Video camera delay feature is inoperative	Video camera delay feature is disabled	ENABLE the video camera delay feature within the Front Display Interface Module (FDIM).
All other image concerns	Video camera	REFER to Diagnostic Routine I .