LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Explorer Base, AWD, 6F50 >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Information Center - Instrumentation, Message Center, And Warning Chimes >> Diagnostic Routine(S) >> Diagnostic Routine BY >> Pinpoint Test

Pinpoint Test

  1. VERIFY THE CUSTOMER CONCERN
    1. Ignition ON.
    2. Verify there is an observable symptom present.
    • Is an observable symptom present? 
    1. Yes:  GO to 2  on page 2.
    2. No:  The system is operating normally at this time. The Diagnostic Trouble Code (DTC) may have been set due to high network traffic or an intermittent fault condition.
  2. CHECK THE COMMUNICATION NETWORK
    1. Ignition ON.
    2. Using a scan tool, perform a network test.
    3. Carry out the network test.
    • Does the All Terrain Control Module (ATCM) module pass the network test? 
    1. Yes:  GO to 3  on page 2.
    2. No:  REFER to Diagnostic Routine AA .
  3. RETRIEVE THE RECORDED Diagnostic Trouble Codes (DTCs) FROM THE Instrument Panel Cluster (IPC) SELF-TEST
    1. Using a scan tool, perform the Instrument Panel Cluster (IPC) self-test.
    • Is Diagnostic Trouble Code (DTC) U3003:16 or Diagnostic Trouble Code (DTC) U3003:17 recorded? 
    1. Yes:  For Diagnostic Trouble Code (DTC) U3003:16, REFER to Diagnostic Routine BD .

      For Diagnostic Trouble Code (DTC) U3003:17, REFER to Diagnostic Routine BE .

    2. No:  GO to 4  on page 2.
  4. RECHECK THE Instrument Panel Cluster (IPC) Diagnostic Trouble Codes (DTCs)
    NOTE: If new modules were installed prior to the Diagnostic Trouble Code (DTC) being set, the module configuration can be incorrectly set during the Programmable Module Installation (PMI) or the Programmable Module Installation (PMI) may not have been carried out.
    1. Clear the Diagnostic Trouble Codes (DTCs).
    2. Wait 10 seconds.
    3. Repeat the Instrument Panel Cluster (IPC) self-test.
    • Is Diagnostic Trouble Code (DTC) U0138:00 still present? 
    1. Yes:  GO to 5  on page 3.
    2. No:  The system is operating correctly at this time. The Diagnostic Trouble Code (DTC) may have been set due to high network traffic or an intermittent fault condition.
  5. CHECK FOR Diagnostic Trouble Code (DTC) U0138:00 SET IN OTHER MODULES
  1. Clear all Diagnostic Trouble Codes (DTCs).
  2. Ignition OFF.
  3. Ignition ON.
  4. Wait 10 seconds.
  5. Using the scan tool, perform self-test.
  6. Retrieve the continuous memory Diagnostic Trouble Codes (DTCs) from all modules.
  1. Yes:  INSTALL a new All Terrain Control Module (ATCM). REFER to ALL TERRAIN CONTROL MODULE (ATCM) .
  2. No:  INSTALL a new Instrument Panel Cluster (IPC). REFER to INSTRUMENT PANEL CLUSTER (IPC) .
scientia non olet · About LEMON Manuals