LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Explorer Base, AWD, 6F50 >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Information Center - Instrumentation, Message Center, And Warning Chimes >> Diagnostic Routine(S) >> Diagnostic Routine AP >> Pinpoint Test

Pinpoint Test

  1. CHECK THE KEY-IN-IGNITION WARNING CHIME OPERATION
    1. Ignition OFF.
    2. On vehicles without Intelligent Access (IA), place the ignition in the OFF position with the key in the ignition lock cylinder, open the Left Hand (LH) front door and observe the key-in-ignition warning chime operation.
    3. On vehicles with Intelligent Access (IA), place the ignition in accessory mode, open the Left Hand (LH) front door and observe the key-in-ignition warning chime operation.
    • Does the key-in-ignition warning chime operate correctly? 
    1. Yes:  GO to 2  on page 2.
    2. No:  INSTALL a new Instrument Panel Cluster (IPC). REFER to INSTRUMENT PANEL CLUSTER (IPC) .
  2. CHECK THE DRIVER SAFETY BELT BUCKLE SWITCH
    1. Ignition ON.
    2. Using a scan tool, view the Restraints Control Module (RCM) Parameter Identifications (PIDs).
    3. Select and monitor the Restraints Control Module (RCM) driver safety belt buckle Parameter Identification (PID) (SBELT_D_ST) while buckling and unbuckling the driver safety belt.
    • Does the Parameter Identification (PID) display BUCKLED with the safety belt buckled and UNBUCKLED with the safety belt unbuckled? 
    1. Yes:  GO to  4 on page 2.
    2. No:  INSTALL a new safety belt buckle. REFER to SAFETY BELT BUCKLE AND PRETENSIONER
  3. CHECK THE SAFETY BELT WARNING INDICATOR FOR CORRECT OPERATION
    1. Ignition ON.
    2. Within one minute, buckle then unbuckle the Left Hand (LH) front safety belt.
    3. Verify the safety belt warning indicator illuminates with the safety belt unbuckled and turns off when buckled.
    • Does the safety belt warning indicator operate correctly? 
    1. Yes:  GO to  2 on page 2.
    2. No:  REFER to Diagnostic Routine S .
  4. CHECK THE SPEEDOMETER OPERATION
    1. Verify the speedometer is operating.
    • Does the speedometer operate? 
    1. Yes:  GO to 5  on page 2.
    2. No:  REFER to Diagnostic Routine G .
  5. CHECK THE Belt-Minder® CONFIGURATION
  1. NOTE: Make sure that an administrator key is used for this test and not a MyKey® programmed key. When a MyKey® programmed key is used, the Belt-Minder® is automatically turned on and cannot be disabled (if previously disabled by an administrator, the Belt-Minder® remains disabled when an administrator key is used).

Verify the Belt-Minder® is activated or configured on for the seating position in question. REFER to BELT-MINDER? DEACTIVATING AND ACTIVATING .

  1. Yes:  If the Belt-Minder® is always on above 4.8 kmh (3 mph) with the safety belt unfastened, the system is operating normally.

    If the Belt-Minder® is always on with the safety belt fastened or never on with the safety belt unfastened above 4.8 kmh (3 mph), INSTALL a new Restraints Control Module (RCM). REFER to RESTRAINTS CONTROL MODULE (RCM) .

  2. No:  ACTIVATE the Belt-Minder® for the seating position in question. REFER to BELT-MINDER? DEACTIVATING AND ACTIVATING .
scientia non olet · About LEMON Manuals