Wiper Pivot Arm - Front

Wiper Pivot Arm - Front

Removal

1. Remove the wiper pivot arm nut cover.

2. Remove the wiper pivot arm nut.

3. Using a suitable 2 jaw puller, remove the wiper pivot arm.

Installation

1. Using a wire brush, clean the wiper pivot arm shaft.





2. Cycle and park the windshield wipers.

3. Install the wiper pivot arm.

4. Align the RH (Right Hand) and LH (Left Hand) windshield wiper blades to the alignment marks on the windshield glass.





5. Install the 2 wiper pivot arm nuts.

- Tighten to 30 Nm (22 lb-ft).

6. Install the wiper pivot arm nut cover.