DTC P0344: Camshaft Position Sensor A Circuit Intermittent (Bank 1 Or Single Sensor)
WARNING: This page is about a different variant/trim than selected.
P0344 - CAMSHAFT POSITION SENSOR A CIRCUIT INTERMITTENT (BANK 1 OR SINGLE SENSOR)
| Description: | The test fails when the powertrain control module (PCM) detects an intermittent signal from the camshaft position (CMP) sensor. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Harness routing, harness alterations, incorrect shielding, or electrical interference from other systems may have an intermittent impact on the CMP signal. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST DR . | ||