LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Hybrid, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 30 (Clutch Controls) >> Removal And Installation >> Clutch Pedal >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the master cylinder push rod.
  2. Remove the 2 clutch master cylinder nuts.
    • To install, tighten to 23 Nm (17 lb-ft).
  3. Remove the clutch pedal and bracket assembly nut.
    • To install, tighten to 23 Nm (17 lb-ft).
  4. Remove the clutch pedal and bracket assembly.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals