Clutch Disc and Pressure Plate: Installation

WARNING: This page is about a different variant/trim than selected.

Using the Clutch Aligner, position the clutch disc on the flywheel.

Fig 1: Positioning Clutch Disc On Flywheel Using The Clutch Aligner
Courtesy of FORD MOTOR CO.
Position the clutch pressure plate on the flywheel and install the 6 clutch pressure plate bolts.
- Tighten to 29 Nm (21 lb-ft) in the sequence shown in illustration.
Fig 2: Identifying Clutch Pressure Plate Bolt Tighten Sequence
Courtesy of FORD MOTOR CO.
Install the transaxle. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION article.