LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Hybrid, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Cooling (Except Hybrid)) >> Removal And Installation >> Radiator - 2.5L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Remove the cooling fan motor and shroud. For additional information, refer to COOLING FAN MOTOR AND SHROUD  in this service information.
  3. Disconnect the upper radiator hose from the radiator.
  4. Disconnect the lower degas bottle-to-radiator hose from the radiator.
  5. Disconnect the lower radiator hose from the radiator.
  6. Remove the 2 A/C condenser-to-radiator bolts and position aside the A/C condenser.
    • To install, tighten to 8 Nm (71 lb-in).
  7. Remove the radiator.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals