LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Hybrid, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Cooling (Except Hybrid)) >> Removal And Installation >> Coolant Pump Housing - 3.0L (4V) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING  in this service information.
  2. Remove the Throttle Body (TB). For additional information, refer to FUEL CHARGING AND CONTROLS - 3.0L (4V) article.
  3. Remove the coolant pump belt. For additional information, refer to ACCESSORY DRIVE - 3.0L (4V) article.
  4. Disconnect the upper radiator hose from the coolant pump housing.
  5. Disconnect the lower radiator hose from the thermostat housing.
  6. Remove the 2 coolant inlet pipe bolts.
    • To install, tighten to 10 Nm (89 lb-in).
  7. Disconnect both heater hoses from the coolant pump housing.
  8. Remove the 3 bolts, 2 nuts and the coolant pump housing.
    • Remove and discard the O-ring seals and gasket.
    • To install, tighten to 10 Nm (89 lb-in).
  9. To install, reverse the removal procedure.
    • Install new O-ring seals and gasket.
  10. Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING  in this service information.
scientia non olet · About LEMON Manuals