LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Hybrid, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Cooling (Except Hybrid)) >> Removal And Installation >> Coolant Pump - 3.0L (4V) >> Removal

Coolant Pump - 3.0L (4V): Removal

WARNING: This page is about a different variant/trim than selected.
  1. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING  in this service information.
  2. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING - 3.0L (4V) article.
  3. Disconnect the lower radiator hose from the thermostat housing.
  4. Remove the coolant pump belt. For additional information, refer to ACCESSORY DRIVE - 3.0L (4V) article.
  5. Remove the 3 bolts and the coolant pump.
    • Remove and discard the gasket.
scientia non olet · About LEMON Manuals