LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Hybrid, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Manual Transaxle) >> General Procedures >> Vehicle Speed Sensor (VSS) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
    2. NOTE: The electrical connector and the Vehicle Speed Sensor (VSS) are accessed from the top of the transaxle.
  2. Remove the VSS  bolt.
  3. Disconnect the electrical connector and remove the VSS  .
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals