Transaxle Draining and Filling: Material

WARNING: This page is about a different variant/trim than selected.

MATERIAL SPECIFICATIONS

Item	Specification
SAE 75W-90 API GL-4 Gear Oil XT-4-QGL	WSS-M2C203-A1
Silicone Gasket and Sealant TA-30	WSE-M4G323-A4

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
Remove the drain plug and drain the fluid.

Fig 1: Remove/Install Drain Plug
Courtesy of FORD MOTOR CO.

NOTE: Use a new gasket and apply sealant on the drain plug.

Fig 2: Remove/Install Drain Plug

Courtesy of FORD MOTOR CO.

Install the drain plug.
- Tighten to 35 Nm (26 lb-ft).
Remove the fill level inspection plug.

Fig 3: Locating Fill Level Inspection Plug
Courtesy of FORD MOTOR CO.
Fill the transmission with gear oil through the fill level inspection plug hole, until level with the fill level inspection plug hole.

NOTE: Use a new gasket and apply sealant on the fill level inspection plug.

Fig 4: Locating Fill Level Inspection Plug

Courtesy of FORD MOTOR CO.