LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Hybrid, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Manual Transaxle) >> General Procedures >> Halfshaft Seal >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
NOTE: New halfshaft oil seals should be installed any time the halfshafts are removed. Failure to install new halfshaft seals may result in transmission oil leak(s).
NOTE: RH intermediate shaft oil seal shown in illustration, LH halfshaft oil seal similar.
  1. Remove the RH intermediate shaft or LH halfshaft. For additional information, refer to FRONT DRIVE HALFSHAFTS article.
  2. Using the Slide Hammer with the Bearing Cup Remover, remove the RH intermediate shaft oil seal or the LH halfshaft oil seal.
Fig 1: Removing Intermediate Shaft Oil Seal Using Special Tools
G06098192Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals