LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Hybrid, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Anti-Theft System - Anti-Theft Perimeter (Except Hybrid)) >> Removal And Installation >> Passive Anti-Theft System (PATS) Transceiver >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Remove the steering column opening cover. For additional information, refer to Instrument Panel - Exploded View in INSTRUMENT PANEL .
  2. Remove the 3 screws and the lower steering column shroud.
  3. Disconnect the Passive Anti-Theft System (PATS) transceiver electrical connector.
  4. Using a suitable tool (such as a dentist pick), release the tabs and remove the PATS  transceiver.
    5. NOTE: Replacement of the PATS  transceiver does not require the PATS keys to be programmed into the Instrument Cluster (IC) again.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals