Symptom Chart - NVH
WARNING: This page is about a different variant/trim than selected.
NOTE:
NVH symptoms will be identified using the diagnostic tools that are available. For a list of these tools, an explanation of their uses and a glossary of common terms, refer to
NOISE, VIBRATION & HARSHNESS
article. Since it is possible any one of multiple systems may be the cause of a symptom, it may be necessary to use a process of elimination type of diagnostic approach to pinpoint the responsible system. If this is not the causal system for the symptom, refer back to
NOISE, VIBRATION & HARSHNESS
article for the next likely system and continue diagnosis. SYMPTOM CHART - NVH
| Condition |
Possible Sources |
Action |
|
|
- A/C compressor clutch air gap out of specification
|
- CHECK and ADJUST the A/C compressor clutch gap if necessary. REFER to AIR CONDITIONING (A/C) CLUTCH AIR GAP ADJUSTMENT in this service information. TEST the system for normal operation.
- If the A/C compressor clutch gap is OK, INSTALL an A/C compressor clutch. REFER to
CLIMATE CONTROL
article. TEST the system for normal operation.
|
- A/C compressor pulley bearing worn
|
- INSPECT the A/C compressor pulley bearing for roughness. If bearing roughness is found, INSTALL an A/C compressor pulley. REFER to
CLIMATE CONTROL
article. TEST the system for normal operation.
|
- A/C compressor bearing worn
|
- INSPECT the A/C compressor bearing for roughness. If bearing roughness is found, INSTALL an A/C compressor. REFER to
CLIMATE CONTROL
article. TEST the system for normal operation.
|