Pinpoint Test AO: The Headlamps On Warning Chime Is Inoperative

AO1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Monitor the safety belt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.
- Does the safety belt warning chime operate for approximately 6 seconds?
- Yes: GO to AO2 .
- No: INSTALL a new IC . REFER to INSTRUMENT CLUSTER (IC) in this service information. TEST the system for normal operation.
AO2 CHECK THE EXTERIOR LAMPS OPERATION
- Ignition OFF.
- Place the headlamp switch in the PARKING LAMPS or HEADLAMP ON position.
- Do the headlamps or parking lamps operate?
- Yes: GO to AO3 .
- No: REFER to EXTERIOR LIGHTING SYSTEM article.
AO3 CHECK THE DOOR AJAR WARNING INDICATOR OPERATION
- Ignition ON.
- Open then close the LH front door while observing the door ajar warning indicator.
- Does the door ajar warning indicator operate correctly?
- Yes: INSTALL a new SJB . REFER to MULTIFUNCTION ELECTRONIC MODULE article. TEST the system for normal operation.
- No: GO to PINPOINT TEST N .