LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, FWD, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Power Brake Actuation -- Brake Booster >> Removal And Installation >> Brake Booster Travel Sensor - Hybrid >> Removal and Installation

Removal and Installation

  1. Disconnect the brake booster travel sensor electrical connector.
  2. Release the brake booster travel sensor retainer ring and remove the travel sensor.
    Fig 1: Removing Travel Sensor
    G06094483Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
  4. Following the scan tool instructions, carry out the Multi-Calibration Routine.
scientia non olet · About LEMON Manuals