LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Oil Level Indicator and Tube >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Remove the Air Cleaner (ACL) outlet pipe and the ACL  . For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING - 3.0L (4V) article.
  2. Detach the upper radiator hose from the 2 retaining clips on the cooling fan shroud.
    • Position the hose aside.
  3. Remove the 4 upper radiator support bracket bolts.
    • To install, tighten to 10 Nm (89 lb-in).
  4. Remove the oil level indicator.
  5. Remove the 3 bolts and position aside the heat shield.
    • To install, tighten to 10 Nm (89 lb-in).
  6. Detach the wiring harness retainer from the oil level indicator tube.
  7. Remove the stud bolt and then remove the oil level indicator tube by guiding it between the radiator support and the cooling fan.
    • Remove and discard the O-ring seal.
    • To install, tighten to 10 Nm (89 lb-in).
    8. NOTE: Install a new O-ring seal and lubricate with clean engine oil.
    NOTE: Installation of the oil level indicator may require the assistance of a second technician to align the tube with the orifice.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals