LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Flexplate >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Remove the transaxle. For additional information, refer to AUTOMATIC TRANSAXLE/TRANSMISSION - 6F35 article.
  3. Remove the bolts and the flexplate.
    • To install, tighten to 80 Nm (59 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals