LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Exhaust Manifold - RH >> Removal

Exhaust Manifold - RH: Removal

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Remove the 3.0L RH catalytic converter. For additional information, refer to EXHAUST SYSTEM article.
  3. Disconnect the Heated Oxygen Sensor (HO2S) electrical connector.
  4. Remove the 3 exhaust manifold heat shield bolts and the heat shield.
  5. Remove the EGR tube fitting nut from the exhaust manifold.
  6. Remove and discard the 6 exhaust manifold nuts.
  7. Remove the exhaust manifold and discard the exhaust manifold gasket.
  8. Remove and discard the 6 exhaust manifold studs.
  9. Clean and inspect the exhaust manifold. For additional information, refer to ENGINE MECHANICAL SYSTEM - GENERAL INFORMATION article.
scientia non olet · About LEMON Manuals