Removal and Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: The Transmission Range (TR) sensor is part of the selector lever assembly.

All vehicles

Place the selector lever in the D position.

Fig 1: Identifying Selector Lever In D Position
Courtesy of FORD MOTOR CO.
Gently pry up to remove the selector lever trim ring.

Fig 2: Locating Selector Lever Trim Ring
Courtesy of FORD MOTOR CO.
Lift the center console lid and remove the center console compartment tray.

Fig 3: Locating Center Console Compartment Tray
Courtesy of FORD MOTOR CO.
Remove the top finish panel from the center console.

Fig 4: Locating Top Finish Panel
Courtesy of FORD MOTOR CO.
Disconnect the power outlet electrical connector.

Fig 5: Locating Power Outlet Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the selector lever cable from the selector lever assembly.
1. Disconnect the selector lever cable end from the selector lever.
2. Remove the selector lever cable from the selector lever bracket.
Fig 6: Identifying Selector Lever Cable End And Selector Lever
Courtesy of FORD MOTOR CO.
Disconnect the TR sensor electrical connector and disconnect the wiring harness fastener from the selector lever.

Fig 7: Locating TR Sensor Electrical Connector
Courtesy of FORD MOTOR CO.
Disconnect the wiring harness retainers from the selector lever.

Fig 8: Locating Wiring Harness Retainers
Courtesy of FORD MOTOR CO.
Disconnect the electrical connectors from the selector lever.
1. Disconnect the selector lever electrical connector.
2. Remove the vehicle harness connector from the selector lever.
Fig 9: Identifying Selector Lever Electrical And Vehicle Harness Connectors
Courtesy of FORD MOTOR CO.

All-Wheel Drive (AWD) vehicles
Pull the All-Wheel Drive (AWD) module straight back and remove it from the back of the selector lever.

Fig 10: Locating All-Wheel Drive (AWD) Module
Courtesy of FORD MOTOR CO.

All vehicles
Remove the 2 screws from the center console.

Fig 11: Locating Center Console Screws
Courtesy of FORD MOTOR CO.
Remove the 4 bolts and remove the selector lever assembly.
- To install, tighten to 25 Nm (18 lb-ft).
Fig 12: Locating Selector Lever Assembly Bolts
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure. Adjust the selector lever cable. For additional information, refer to SELECTOR LEVER CABLE ADJUSTMENT in this service information.