LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Automatic Transmission - External Controls (6F35) (Except Hybrid)) >> General Procedures >> Selector Lever Cable Adjustment

Selector Lever Cable Adjustment

WARNING: This page is about a different variant/trim than selected.
  1. Place the selector lever in the D position.
    Fig 1: Identifying Selector Lever In D Position
    G06098046Courtesy of FORD MOTOR CO.
  2. Disconnect the selector lever cable end from the manual control lever.
    Fig 2: Disconnecting Selector Lever Cable
    G06097005Courtesy of FORD MOTOR CO.
  3. Place the manual control lever in the D position.
    1. Rotate the manual control lever counterclockwise to the PARK position.
    2. Rotate the manual control lever clockwise 3 detents to the D position.
    Fig 3: Rotating Manual Control Lever Counterclockwise To Park Position
    G06098048Courtesy of FORD MOTOR CO.
  4. Release the selector lever cable adjuster lock.
    1. Pull out on the adjuster lock tabs.
    2. Slide the lock over to unlock the selector lever cable.
    Fig 4: Pulling Out On Adjuster Lock Tabs
    G06098049Courtesy of FORD MOTOR CO.
  5. Align the selector lever cable end to the manual control lever ball stud and install it with the adjuster unlocked.
    Fig 5: Locating Selector Lever Cable End
    G06098050Courtesy of FORD MOTOR CO.
  6. Slide the adjuster tab in place to lock the selector lever cable.
Fig 6: Sliding Adjuster Tab In Place To Lock Selector Lever Cable
G06098051Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals