LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Automatic Transmission Cooler - (Hybrid)) >> Removal And Installation >> Motor Electronics Cooler

Motor Electronics Cooler

WARNING: This page is about a different variant/trim than selected.
Fig 1: Motor Electronics Cooler Replacement Components With Torque Specifications
G06098023Courtesy of FORD MOTOR CO.
ITEM DESCRIPTION

Item Part Number Description
1 8B273 Motor Electronics Cooling System (MECS) radiator inlet hose
2 8B274-B MECS  radiator outlet hose
3 N606676-S MECS  radiator bolts
4 8005-B MECS  radiator
  1. Drain the Motor Electronics Cooling System (MECS). For additional information, refer to MOTOR ELECTRONICS COOLING SYSTEM DRAINING AND FILLING  in this service information.
  2. Remove the front bumper cover. For additional information, refer to BUMPER SYSTEM article.
  3. Loosen the hose clamp and disconnect the MECS  radiator inlet hose.
    Fig 2: Locating MECS Radiator Inlet Hose Clamp
    G06098024Courtesy of FORD MOTOR CO.
  4. Loosen the hose clamp and disconnect the MECS  radiator outlet hose.
    Fig 3: Locating MECS Radiator Outlet Hose Clamp
    G06098025Courtesy of FORD MOTOR CO.
    5. NOTE: RH shown in illustration, LH similar.
    Fig 4: Locating MECS Radiator Bolts
    G06098026Courtesy of FORD MOTOR CO.
  5. Remove the MECS  radiator bolts.
    • To install, tighten to 6 Nm (53 lb-in).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals