LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Fuel Charging System & Fuel Control System - (Hybrid)) >> Removal And Installation >> Fuel Rail >> Installation

Fuel Rail: Installation

WARNING: This page is about a different variant/trim than selected.
    NOTE: Use O-ring seals that are made of special fuel-resistant material. Use of ordinary O-rings can cause the fuel system to leak. Do not reuse the O-ring seals.
    NOTE: Install 8 new fuel injector O-ring seals and lubricate them with clean engine oil.
  1. Install the 4 fuel injectors and the 4 retainer clips on the fuel rail.
  2. Install the fuel rail and injectors as an assembly.
  3. Install the 2 fuel rail stud bolts.
    • Tighten to 23 Nm (17 lb-ft).
  4. Attach the 2 pin-type wire harness retainers to the fuel rail.
  5. Position the radio capacitor and install the nut.
    • Tighten to 10 Nm (89 lb-in).
  6. Connect the 4 fuel injector electrical connectors.
  7. Connect the fuel supply tube-to-fuel rail quick connect coupling. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION article.
  8. Connect the battery ground cable. For additional information, refer to BATTERY, BATTERY MOUNTING SYSTEM & BATTERY CABLES article.
scientia non olet · About LEMON Manuals