Removal and Installation
WARNING: This page is about a different variant/trim than selected.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
- Disconnect the FP control module electrical connector.
- Remove the 2 bolts and the FP
control module.
- To install, tighten to 5 Nm (44 lb-in).
- To install, reverse the removal procedure.
NOTE:
The Fuel Pump (FP) control module is located near the left rear side of the fuel tank.
NOTE:
Do not overtighten the fasteners or damage will occur.