LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Fuel Charging System & Fuel Control System - 3.0L (4V)) >> Removal And Installation >> Fuel Rail >> Installation

Fuel Rail: Installation

WARNING: This page is about a different variant/trim than selected.
    NOTE: Use O-ring seals that are made of special fuel-resistant material. Use of ordinary O-rings can cause the fuel system to leak. Do not reuse the O-ring seals.
    NOTE: The upper and lower fuel injector O-ring seals are similar in appearance, but are not interchangeable.
    NOTE: Install new fuel injector O-ring seals and lubricate them with clean engine oil.
  1. Install the 6 fuel injectors and clips on the fuel rail.
  2. Position the fuel rail and install the bolts.
    • Tighten to 10 Nm (89 lb-in).
  3. Connect the engine wire harness and the fuel charging wire harness pin-type retainers to the fuel rail.
  4. Connect the 4 wire harness pin-type retainers to the fuel rail.
  5. Connect the fuel jumper tube-to-fuel rail quick connect coupling. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION article.
  6. Connect the 6 fuel injector electrical connectors.
  7. Install the upper intake manifold. For additional information, refer to ENGINE MECHANICAL - 3.0L (4V) article.
  8. Connect the battery ground cable. For additional information, refer to BATTERY, BATTERY MOUNTING SYSTEM & BATTERY CABLES article.
scientia non olet · About LEMON Manuals