LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Electronic Engine Controls - (Hybrid)) >> Removal And Installation >> Powertrain Control Module (PCM) >> Removal

Powertrain Control Module (PCM): Removal

WARNING: This page is about a different variant/trim than selected.
  1. Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION article.
  2. Detach the wiring harness retainer from the cowl stud bolt.
  3. Disconnect the 3 PCM electrical connectors.
  4. Remove the 2 bolts and the PCM.
  5. Remove and inspect the PCM cowl seal. Install new if damaged.
scientia non olet · About LEMON Manuals