LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Electronic Engine Controls - (Hybrid)) >> Removal And Installation >> Manifold Absolute Pressure (MAP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Remove the Throttle Body (TB). For additional information, refer to FUEL CHARGING AND CONTROLS - HYBRID article.
  3. Disconnect the Manifold Absolute Pressure (MAP) sensor electrical connector.
  4. Using a tool like KD Tool #58181 or Lisle T25 Torx Bit, remove the screw and the MAP  sensor.
    • To install, tighten to 3 Nm (27 lb-in).
    5. NOTE: Lubricate the MAP  sensor O-ring seal with clean engine oil.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals