LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Electronic Engine Controls - (Hybrid)) >> Removal And Installation >> Knock Sensor (KS) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Remove the intake manifold. For additional information, refer to ENGINE MECHANICAL - 2.5L HYBRID article.
  3. Remove the bolt and the Knock Sensor (KS).
    • To install, tighten to 20 Nm (177 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals