LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Electronic Engine Controls - (Hybrid)) >> Removal And Installation >> Cylinder Head Temperature (CHT) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Detach the Cylinder Head Temperature (CHT) sensor cover and position aside.
  2. Disconnect the CHT  sensor electrical connector.
  3. Remove the CHT  sensor.
    • To install, tighten to 12 Nm (106 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals