LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Electronic Engine Controls - 3.0L (4V)) >> Removal And Installation >> Manifold Absolute Pressure (MAP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the Manifold Absolute Pressure (MAP) sensor electrical connector.
  2. Remove the bolt and the MAP  sensor.
    • To install, tighten to 6 Nm (53 lb-in).
    • When installing the sensor, if the bolt fails to hold specified torque, relocate the sensor and retain, using the auxiliary bolt hole in the upper intake manifold.
    3. NOTE: Clean and inspect the sealing surface.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals