LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Electronic Engine Controls - 3.0L (4V)) >> Removal And Installation >> Knock Sensor (KS) >> Installation

Knock Sensor (KS): Installation

WARNING: This page is about a different variant/trim than selected.

Engine block-mounted KS 

  1. Install the KS  and the bolt.
    • Tighten to 25 Nm (18 lb-ft).
  2. Connect the KS  electrical connector.
  3. Install the lower intake manifold. For additional information, refer to ENGINE MECHANICAL - 3.0L (4V) article.

    Cylinder head-mounted KS 

  4. Install the KS  and the bolt.
    • Tighten to 25 Nm (18 lb-ft).
  5. Connect the KS  electrical connector.
scientia non olet · About LEMON Manuals