Differential Seals - RH: Installation

All Vehicles 

1. Using the Differential Seal RH and LH Installer (two sided tool eCVT) and Driver 32 Inch Handle, install the RH differential seal.
   Fig 1: Installing RH Differential Seal Using Differential Seal RH And LH Installer (Two Sided Tool ECVT) And Driver 32 Inch Handle

   Courtesy of FORD MOTOR CO.

   AWD 

2. Install the PTU  . For additional information, refer to TRANSFER CASE - POWER TRANSFER UNIT (PTU) article

   FWD 

3. Install the intermediate shaft. For additional information, refer to FRONT DRIVE HALFSHAFTS article.

   All Vehicles 

4. Clean the drain plug threads and apply a small amount of thread sealant on the threads, install the drain plug.
   • Tighten to 40 Nm (30 lb-ft).
     Fig 2: Locating Drain Plug

     Courtesy of FORD MOTOR CO.
5. Remove the fill plug on the side of the transaxle.
   Fig 3: Locating Fill Plug

   Courtesy of FORD MOTOR CO.
6. Fill the transaxle with clean transmission fluid as specified until the level reaches the bottom of the fill plug hole.
NOTE: Clean the area around the fill plug removing transmission fluid that may have spilled on the transaxle case.
7. Install the fill plug.
   • Tighten to 40 Nm (30 lb-ft).
     Fig 4: Locating Fill Plug

     Courtesy of FORD MOTOR CO.
NOTE: The check and fill plug is located on the left side of the transaxle near the front.
NOTE: The transmission fluid is checked and filled by removing the fill plug and adding transmission fluid to the bottom of the fill plug hole.
8. Start the engine and check for correct forward and reverse operation.