LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Automatic Transmission (6F35) (Except Hybrid)) >> Diagnosis And Testing >> Transaxle Drive Cycle Test >> Before Pinpoint Tests

Before Pinpoint Tests

WARNING: This page is about a different variant/trim than selected.
NOTE: Prior to entering pinpoint tests, check the PCM wiring harness for correct connections, bent or broken terminals, corrosion, loose wires, correct routing, correct seals and their condition. Check the PCM, sensors and actuators for damage. Refer to the INTRODUCTION article.
NOTE: If a concern exists after the electrical diagnosis has been carried out, refer to DIAGNOSIS BY SYMPTOM  in this service information.

If DTCs appear while carrying out the OBD  test, refer to the DIAGNOSTIC TROUBLE CODE (DTC) CHARTS  in this service information for the appropriate repair procedure. Prior to entering pinpoint tests, refer to TSBs for transaxle concerns.

scientia non olet · About LEMON Manuals