After On-Board Diagnostic (OBD)

WARNING: This page is about a different variant/trim than selected.

NOTE: The vehicle wiring harness, PCM and non-transaxle sensors may affect transaxle operations. Service these concerns first.

After the On-Board Diagnostic (OBD) procedures are complete, service all DTCs.

Begin with non-transaxle related DTCs, then service any transaxle related DTCs . Refer to the DIAGNOSTIC TROUBLE CODE (DTC) CHARTS in this service information for information on condition and symptoms. This chart is helpful referring to the correct article(s) and to aid in diagnosing internal transaxle concerns and external non-transaxle inputs. The pinpoint tests are used in diagnosing electrical concerns of the transaxle. Make sure the vehicle wiring harness and PCM are diagnosed as well. Refer to the INTRODUCTION article for diagnosing non-transaxle electronic components. The diagnostic routine hydraulic/mechanical charts will help in diagnosing internal transaxle concerns and external non-transaxle inputs.