Transmission Fluid Level Check
WARNING: This page is about a different variant/trim than selected.
NOTE:
Transmission fluid should be checked at normal operating temperature 85°C-93°C (185°F-200°F) on a level surface. Normal operating temperature can be reached after approximately 32 km (20 mi) of driving and can be checked using the scan tool.
Check the transmission fluid level during normal maintenance. If the transaxle starts to slip, shifts slowly or shows signs of leaking, the transmission fluid level should be checked.
- With the selector lever in PARK, engine at idle, brake pedal applied, move the selector lever through each gear range and allow engagement of each gear. Place the selector lever in the PARK position.
- Wipe the transmission fluid level indicator cap and remove the transmission fluid level indicator.
- Wipe the transmission fluid level indicator with a clean cloth.
- Install the transmission fluid level indicator back in the transmission fluid filler tube until it is fully seated.
- Remove the transmission fluid level indicator. The transmission fluid level should be within the crosshatch area.
ITEM DESCRIPTION CHART
| Item | Description |
|---|---|
| 1 | Correct transmission fluid level at operating temperature 85°C-93°C (185°F-200°F) |
| 2 | Minimum transmission fluid level mark |
| 3 | Maximum transmission fluid level mark |
| 4 | Flat tow transmission fluid level |