LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Automatic Transmission (6F35) (Except Hybrid)) >> Diagnosis And Testing >> Diagnosis By Symptom >> Diagnostic Routines >> Shift Concerns: Soft/Slipping 4-3 Shift (Automatic)

Shift Concerns: Soft/Slipping 4-3 Shift (Automatic)

WARNING: This page is about a different variant/trim than selected.
POSSIBLE COMPONENT REFERENCE CHART

Possible Component Reference/Action
237 - ELECTRICAL ROUTINE 
Solenoid Body 
  • Verify solenoid body strategy data stored in the PCM, download new identification and strategy as necessary. Refer to SOLENOID BODY STRATEGY  in this service information.
  • Incorrect solenoid body strategy data stored in the PCM
337 - HYDRAULIC/MECHANICAL ROUTINE 
Main Control Valve Body   
  • Bolts out of torque specification
  • Tighten bolts to specification.
  • Gaskets and separator plate - damaged, off location
  • Inspect for damage. Install new as required.
  • Overdrive regulator and boost valves, springs, clips - loose, stuck, binding, missing, misassembled
  • Inspect for damage. Repair or install new as required.
  • Direct regulator and boost valves, springs, clips - loose, stuck, binding, missing, misassembled, clutch failed off
  • Inspect for damage. Repair or install new as required.
  • Shift Solenoid B (SSB) or Shift Solenoid D (SSD) not functioning correctly
Overdrive Clutch Assembly   
  • Seals - damaged
  • Inspect for damage. Install new as required.
  • Piston - damaged
  • Inspect for damage. Install new as required.
  • Friction - damaged, worn
  • Inspect for damage. Install new as required.
  • Cylinder hub - damaged
  • Inspect for damage. Install new as required.
  • Return spring assembly - damaged
  • Inspect for damage. Install new as required.
Direct Clutch Assembly   
  • Seals - damaged
  • Inspect for damage. Install new as required.
  • Piston - damaged
  • Inspect for damage. Install new as required.
  • Friction - damaged, worn
  • Inspect for damage. Install new as required.
  • Cylinder hub - damaged
  • Inspect for damage. Install new as required.
  • Return spring assembly - damaged
  • Inspect for damage. Install new as required.