Other Concerns: Transaxle Overheating

WARNING: This page is about a different variant/trim than selected.

POSSIBLE COMPONENT REFERENCE CHART

Possible Component	Reference/Action
267 - ELECTRICAL ROUTINE
No electrical concerns
367 - HYDRAULIC/MECHANICAL ROUTINE
Transmission Fluid
Incorrect transmission fluid level	Check transmission fluid level and adjust as necessary. Refer to PRELIMINARY INSPECTION in this service information.
Condition	Carry out transmission fluid condition check. Refer to PRELIMINARY INSPECTION in this service information.
Transmission Fluid Cooler Tubes	Inspect for damage. Repair as required.
Damaged, blocked, reversed, leaking	Inspect for damage. Repair as required.
Auxiliary Cooler	Inspect for damage. Repair as required.
Damaged, blocked, restricted or incorrectly installed	Inspect for damage. Repair as required.
Vehicle Concerns Causing Engine Overheating	Refer to ENGINE COOLING article.
	Refer to ENGINE COOLING article.
Main Control Valve Body
Torque converter regulator valve/spring - stuck, damaged	Inspect for damage. Repair as required.
Torque converter control valve/spring - stuck, damaged	Inspect for damage. Repair as required.
Torque Converter Not Applying	See Routine 250/350 . Inspect for damage. Repair as required.
Seized converter one-way clutch
Excessive Towing Loads	Check GVW.
	Check GVW.
Idle or Driveability Concern	Refer to the INTRODUCTION article.
	Refer to the INTRODUCTION article.
Incorrect Clutch Application or Oil Pressure Control System	Carry out line pressure tests. Refer to SPECIAL TESTING PROCEDURES in this service information and carry out shift point road test. Refer to SHIFT POINT ROAD TEST in this service information. Repair as required. See the LINE PRESSURE CHART , and CLUTCH APPLICATION CHART for specifications. Repair as required.